– 23 –
– 30 –
Preset the (ON TIMER).
• When
(ON TIMER) is set, the air conditioner starts
operation so that the preset room temperature is
almost reached at the ON TIMER time. Check the
settings of the air conditioners when you set the timer.
(Page 28, 29)
Dehumidifying (Condensation control) operation and
(ON TIMER) for heating operation can be set at the
same time.
Dehumidifying (Condensation control) operation controls the condensation which may occur in the morning
while
(ON TIMER) for heating operation warms up the room by the time you wake up.
Combination of (ON TIMER) and (DEHUMIDIFY) button
• Dehumidifying (Condensation control) operation and (ON TIMER) for heating operation for the next morning
can be set in combination before you go to sleep.
The display below is shown in the case where
(ON TIMER) is set for heating operation and then
dehumidifying operation (Condensation control) is executed at 11:38 p.m.
1
Press the (DEHUMIDIFY) button.
(
symbol is displayed)
• The dehumidifying (Condensation control) operation
stops at 1:38 a.m, two hours after the start of the
dehumidifying operation, and the heating operation
starts in order to reach the preset temperature by
6:00 a.m.
2
FURTHER CONVENIENT TIMER FUNCTION
– 31 –
ENGLISH
Configuring the fan speed appropriate for sleeping and stop the operation at specified time.
The display below indicates sleep timer which is set for 2 hours at 11:38 p.m. and the turn off time will be
1:38 p.m.
Press the
(SLEEP) button.
• Every time you press the (SLEEP) button, the mode will change as shown
below.
• Preset time of sleep timer and the time at which the operation stops will be
displayed on the remote controller.
• Fan speed remain “SILENT” during sleep timer operation.
Press the
(SLEEP) button or (CANCEL) button.
Preset the
(ON TIMER).
(Page 28, 29)
Combination of Sleep Timer and On Timer operation
• Set the operation to auto stop by sleep timer operation, it can be set to start the operation next morning by
(ON TIMER). Set (ON TIMER) first and then press the (SLEEP) button.
The display below indicates (ON TIMER) which is set at 6:00 a.m. and 2 hours sleep time at
11:38 p.m.
Press the
(SLEEP) button.
• The unit will turn off in 2 hours (at 1:38 a.m.) and will
turn on in order to reach the preset temperature by
6:00 a.m.
• The time range of sleep timer operation should be
set before
(ON TIMER) time.
1
2
Cancel the sleep timer
CANCEL
• When the sleep timer has been programmed, the unit
will not operate even if the set time is reached unless
the unit receives a signal from the remote controller.
Confirm that sleep timer programming is complete
(beep) and the
(TIMER) indicator of the indoor unit
turns on.
SLEEP TIMER OPERATION
To Next Page
Loading...
