Hitachi RX

3-2 ●Basic operation
3
Print description 2015.07.0712:45
M
Manual
Startup
Menu
Com=0
[Stop ]
Ink operating time １００(hours)
Cumulative op. time １００(hours)
Print count １０００(prints)
Ink pressure  ０．０００(MPa；standard value:０．２５０)
Change
message
Select
message
Overwrite
message
Adjustprint
parameters
Operation
management
Message name[ ]
− ＋
Current user ID : user2
●Confirm the print description, count value, and calendar character contents.
Press the Start switch. (Press for about 2 seconds.)
(Depending on the model, there may not be a Start switch. When the main power switch of 2 is
pressed, the following “Print description” screen appears.)
In the case of turning on the power again, ensure that status indicator lamp is off when Start switch is
pressed.
The “Print description” screen shown below appears.
If the “Login user designation” screen opened, see “3.1.4 Login user designation”.