Hitachi RX

●Start operation 3-3
2015.07.0712:45
M
Manual
Startup
Com=0
＝＝＝＝＝ Ink Jet Startup Confirmation ＝＝＝＝＝
The ink jet will be turned ON.
Solution To turn the ink jet ON, press <Ready>.
Ready
Cancel
Place a piece of wiping paper, etc., against the ink injection port at the end of the print
head and press the Startup → Ready .
●Ink is ejected from the nozzle inside the print head.
●Place a piece of wiping paper, etc., against the ink ejection port in preparation for splashing of the ejected ink.
Startup
4
Print head
Wiping paper, etc.
Press Start up .
Press Ready .