Hitachi RX

3-4 ●Basic operation
● Continuous ejection of ink even though not printing is abnormal. If this occurs, press the Manual .
The Manual Control Menu appears. Stop ink ejection by pressing the No-cleaning stop → OK .
M
Manual
2015.07.0712:45
M
Manual
Shutdown
Com=0
＝＝＝＝＝
Manual Control Menu
＝＝＝＝＝
Start
printing
The current message is
printed.
No-cleaning
stop
Stops ink ejection
without cleaning.
Cancel
＝＝＝＝＝ Shutdown Process Confirmation ＝＝＝＝＝
Shutdown will stop the ink jet.
Solution To stop the ink jet, press <OK>.
OK
Close
Standby
No deflection voltage is
applied. The printer
status becomes Standby.
● For a description of subsequent operation, see “3.1.2 When an error occurred at the start of operation”.
● At ink ejection, ink may momentarily spurt out and soil the paper. However, this is normal.
Wait until the status changes from “Starting” to “Ready”.
● When the temperature is low (approximately 20 C or lower), it may take longer than usual for the printer
to enter the “Ready” state.
5
Input the print target detection signal and check whether or not the print state and
print description are correct.
●If the print target detection signal is input when the status is “Ready”, the set print description is printed.
6
Press Manual .
Press No-cleaning stop .
Press OK .