Hitachi S1 Series User Manual

S1 series standard inverter
-76-
Function
code
Name
Detailed parameter description
Default
value
P05.07
Reserved variables
7: Fault reset
8: Running pause
9: External fault input
10: Frequency increase (UP)
11: Frequency decrease (DOWN)
12: Clear frequency
increase/decrease setting
13: Switch-over between setup A and
setup B
14: Switch-over between
combination setting and A setting
15: Switch-over between
combination setting and setup B
16: Multi-step speed terminal 1
17: Multi-step speed terminal 2
18: Multi-step speed terminal 3
19: Multi-step speed terminal 4
20: Multi-step speed pause
21: Acceleration/deceleration time
selection 1
22: Acceleration/deceleration time
selection 2
25: PID control pause
26: Wobbling frequency pause
27: Wobbling frequency reset
28: Counter reset
29: Switching between speed control
and torque control
30: Acceleration/deceleration
disabled
31: Counter trigger
32: Reserved
33: Clear frequency
increase/decrease setting
temporarily
34: DC brake
35: Switching between motor 1 and
motor 2
36: Command switches to keypad
0

Hitachi S1 Series Specifications

General

Output Frequency	0 - 400 Hz
Overload Capacity	150% for 60 seconds
Frequency	50/60 Hz
Control Method	Sensorless Vector Control
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit
Communication	RS485, Modbus RTU
Output Voltage	3-Phase 200-240VAC, 3-Phase 380-480VAC (Matches Input Voltage)
Cooling Method	Fan Cooled