Hitachi SJ300 Series

30
C073 Communication data length selection
• 07 7-bit data • 08 8-bit data
7
C074 Communication parity selection
• 00 No parity • 01 Even parity
• 02 Odd parity
00
C075 Communication stop bit selection
• 01 1 stop bit • 02 2 stop bits
1
C078 Communication wait time 0.
C081 [O] input span calibration Factory
calibrated
C082 [OI] input span calibration
C083 [O2] input span calibration
C085 Thermistor input tuning 105.0
C086 [AM] terminal offset tuning 0.0
C087 [AMI] terminal meter tuning 80.
C088 [AMI] terminal offset tuning Factory
calibrated
C121 [O] input zero calibration
C122 [OI] input zero calibration
C123 [O2] input zero calibration
C091 Debug mode enable
• 00 Display • 01 No display
00
C101 Up/Down memory mode selection
• 00 Clear last frequency (return to F001)
• 01 Keep last freq. adjusted by UP/DWN
00
C102 Reset mode selection
• 00 Cancel trip state at input signal ON transi-
tion, Stops inverter if in Run Mode
• 01 Cancel trip state at signal OFF transition,
Stops inverter if in Run Mode
• 02 Cancel trip state at input signal ON transi-
tion, no effect if in Run Mode
00
C103 Restart mode after reset
• 00 Restart at 0 Hz
• 01 Resume after frequency matching
00
C111 Overload setting (2) Rated
current of
each inverter
Func.
Code
Name / Description
Default
Value
–FE/FU/FR
Set
Value