2 Features and benets
Start-up benets
TCGB0136 rev.1 - 05/2021
28
2.6.2 Service verication
System operation control
The working order of the system is continuously monitored through the control system. All operating parameters that the
system uses to manage the outdoor and indoor units are continuously supervised.
Assisted-management air conditioning system
The air conditioning system can be conveniently managed using the
Hitachi Service Tools assisted-management software.
This software allows for a laptop, for example, to be connected to
the air conditioning system via an interface connected to the H-LINK
II bus. Through different menus, the software effectively manages
all of the systems connected and obtains data for optimised system
performance.
All of the data obtained using Hitachi Service Tools is collected in different formats and monitored in several ways. The
software user can congure the processing of the data to monitor the parameters of most interest in each installation and
allows reporting of the logged data, exporting each of its screens in different ways.
The data reports can be used to continuously check the correct working order of the system. Any deviation in the ranges
of foreseen values is immediately detected.
Additionally, Service Tools adds the option to control the units remotely, helping the user to evolve its test without moving
away of his computer and it is possible to congure its optional functions from Service Tools without the need to perform
further setup on each unit.
Service Tools can be updated online using an internet connection. If properly congured and registered, Service Tools
will check for new updates and advise the user to download them.
To Next Page
Loading...
Need help?
General
