Hitachi UX2 - Related Regulations; FCC Notice

S１０
Essentials of Daily Operations
Startup procedure⇒Thoroughly read “3.1 Start operation” of instruction
Manual.
(1)Check whether or not the print head cover and the area around the nozzle are soiled by
ink.
● If the area around the nozzle are soiled by ink, clean the print head.
(refer to the “Essentials of print head cleaning” given below)
(2)Turn on the power by pressing the main power switch.
● When stopped only by the Stop switch and the main power switch was not turned off
at the previous operation, the main power switch does not have to be pressed.
(3) Press the On switch. (For about 2 seconds)
● When the main power switch of (2) is pressed, the following “Print description” screen
appears.
●Ensure that status indicator lamp is turned off when On switch is pressed.
(4)Place a piece of wiping paper,etc., against the ink injection port at the end of the print
head and press the STARTUP → Ready.
●Place a piece of wiping paper, etc., against the ink ejection port in preparation for
splashing of the ejected ink.
Loosen the screw
Pull out
Around nozzle
Print head cover
Status indicator lamp
Stop switch
On switch
Main power switch
Print head
Wiping pepar, etc.
Press STARTUP
Press Ready
1