● Ensure that no flame- or arc-generating devices are installed around the product.
- Fire: (Examples) Matches, lighters, cigarettes, heaters, stoves, gas burners,
welders, grinders, static electricity, etc.
- Flammable: (Examples) Ink, makeup
- Arc-generating device: (Examples) Open-type relays, open-type switches, brush
motors, etc.
Before handling ink and makeup, remove static electricity from your body, peripheral
equipment, and so on.
In the interest of safety, place a dry-chemical fire extinguisher near the product.
● Install the product in an adequately ventilated location.
● Do not install the product in an enclosed space.
● Connect the product to exhaust equipment to prevent it from being filled with organic
solvent vapor.
● Secure adequate space for the ink/makeup handling area and product installation site.
At least 200 m
3
must be provided per print head. Ensure that adequate ventilation is
provided.
* If ink or makeup contains any organic solvents or specified chemical substances, it
must be managed under the Industrial Safety and Health Act.
● If extraneous noise enters the product, it may malfunction or break down.
For maximum noise immunity, observe the following installation and wiring
precautions.
- Ensure that 100 or 200 VAC power cables are not bundled with other power supply
cables.
- Insulate the product main body and print head so that they do not come into direct
contact with the conveyor or other devices.
- If the employed print target detector is housed in a metal case, use a plastic
mounting brace to insulate the detector from the conveyor and other devices.
- Ensure that the print target detector wiring is not bundled together with other
power supply cables.
To Next Page
Loading...
