Moving and exchanging units
Procedure
1. Click an existing drive tray in the rack.
The existing drive tray is highlighted in orange.
2. Drag the existing drive tray to the destination drive tray.
An empty tray can be the destination, but you cannot specify a controller and empty
trays for the controller as the destination. You can also drag one to an empty tray or
a controller in Rack 1 only.
Drive trays are exchanged, the box is highlighted in orange, and the unit ID and the
box codes are exchanged accordingly.
3. After moving and exchanging units by dragging and dropping them, click Cable
Figure to display the cable gure. You can also display it by clicking Cable Figure
without creating the conguration gure. You cannot add drive trays below the
controller.
Working with cable figures
The Cable Figure screen shows logical and physical conguration gures.
The total number of racks that can be shown is 2 [U].
The total number of racks that can be shown is 4 [U].
The total number of racks that can be shown is 4 [U].
Moving and exchanging units
Chapter 1: Installation site considerations
Site Preparation Guide for VSP G/F350, G/F370, G/F700, G/F900 28
To Next Page
Loading...
