Hitachi Virtual Storage Platform F900 - Component Weight Specifications

To verify adequate load-bearing capacity, plan for the maximum congur
ation. The
following table lists the weight for maximum congurations. The table also applies to
third-party racks. The weights below do not include the rack itself, so add the weight of
the rack to the values shown below. The maximum allowable weight in the Hitachi rack is
907 kg (2,000 lbs). For more information about racks, see the Hitachi Universal V2 Rack
Reference Guide.
Table 1 CBSS and physical SVP
Component Drive trays Weight
CBSS controller 7 SFF drive trays 565 kg
(1245.6 lbs)
7 LFF drive trays 562 kg
(1239.0 lbs)
7 FMD drive trays 623 kg
(1373.4 lbs)
4 dense intermix drive trays 709 kg
(1563.1 lbs)
Physical SVP N/A 4.5 kg
(10 lbs)
Table 2 CBSL and physical SVP
Component Drive trays Weight
CBSL 7 SFF drive trays 567 kg
(1294.1 lbs)
7 LFF drive trays 564 kg
(1243.4 lbs)
7 FMD drive trays 625 kg
(1377.9 lbs)
8 dense intermix drive trays 1395 kg
(3075.4 lbs)
Physical SVP N/A 4.5 kg
(10 lbs)
Floor load ratings
Chapter 1: Installation site considerations
Site Preparation Guide for VSP G/F350, G/F370, G/F700, G/F900 40