Hitachi Virtual Storage Platform G600 - Page 128

Attribute Description
Required /
Optional Default value
auth.kerberos.<real
m _name>.r
ealm
The realm name set to the
Kerberos server.
Optional
2
None
auth.kerberos.<real
m_name>.kdc
The host name, the IPv4
address, and the port number
of the Kerberos server. Specify
these in the format of "<Host
name or IP address>[:Port
number]".
Optional
2
None
Notes:
1. The item can be omitted if true is specied for
"auth.ldap.<server_name>.dns_lookup".
2. If the specied value is not valid, the default value will be used.
3. To use symbols such as + ; , < = and >, enter a backslash (\) before each symbol.
When using multiple symbols, each symbol must have a backslash before it. For
example, to enter abc++ in the searchdn eld, use \+ instead of + as shown here:
abc\+\+
To enter \ , /, or ", enter a backslash and then the ASCII code in hex for these
symbols.
■ Enter \5c for \.
■ Enter \2f for /.
■ Enter \22 for ".
For example, to enter abc\ in the searchdn eld, enter abc\5c.
Table 8 Kerberos denition (for authorization server)
Attribute Description Required / Optional Default value
auth.group.<realm_
na me>.pr
otocol
LDAP protocol to
use.
■
ldaps: Uses LDAP
over SSL/TLS.
■
starttls: Uses
StartTLS.
Required None
auth.group.<realm_
name>.port
A port number of
the LDAP server.
Must be between 1
and 65535.
1
Optoinal 389
Creating a Kerberos conguration le
Chapter 4: User administration
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 128