Hitachi VM-3100A - Making a Sample Camera Recording

MAKING A SAMPLE CAMERA RECORDING
1.
2.
Connect the POWER SOURCE. (See pages 4 and
5.)
Press “EJECT” Button and insert the cassette so
the transparent window is toward you and the
arrow toward the Cassette Holder. Slide the
Cassette into Cassette Holder as far as it will go.
NOTE: If the power source is not connected to
Camera/Recorder, the Cassette Holder will not
open.
. Press the Cassette Holder. The Holder will latch in
the operating position.
“EJECT” Button
Cassette Holder
. Set “VIDEO/CAM” Select Switch to “CAM”
position.
. Press “POWER” ON/OFF Button on. The Video
Camera/Recorder will enter record/pause mode
automatically. :
NOTE: If the erase prevention tab on the cassette is
removed, the Camera/Recorder will not enter
record/pause mode and recording is not possible.
“VIDEO/CAM” Select Switch
“POWER” ON/OFF
Button
theads may be damaged:
6. Set “IRIS” Control to “AUTO”.
7. Set.“FOCUS AUTO/MAN” Switch to “AUTO”.
NOTE: See page 22 for “EYEPIECE ADJUST-
MENT”.
“FOCUS AUTO/MAN”
Switch
fé O f
9a
ick
oO.
“IRIS” Control
. Now, press Record Start/Stop Button to start
shooting the picture. “REC” indication appears in
the viewfinder and you are now recording the pic-
ture you see through the Electronic Viewfinder.
. Press Record Start/Stop Button to stop recording.
Press the Button again to resume recording. The
“REC” indication in the Electronic Viewfinder goes
off in the record/pause (stand-by) mode.
NOTE: Do not leave the Camera/ Recorder in this.
mode
for
a
prolonged
period
of
time,
or
the
video’
Record Start/Stop Button