Advanced Techniques
5. Press the TITLE ON/OFF button on the remote control to stop recording the title. The
title graphics disappear from the viewfinder and the camcorder can record normally.
Note: Create and store your title before an event you plan to record. Just press the TITLE
ON/OFF button on the remote control to superimpose the title over the scene as you record
it. This method avoids erasing previously recorded material which will happen when you
record a title on a previously recorded tape.
Recording a Created Title while Transferring a Tape
1. Connect the camcorder to the VCR (p.26).
2. Turn on the VCR and set it to record. Hold down the red button on the
CAM/OFF/VIDEO switch while sliding the switch to VIDEO. Press PLAY on the
camcorder.
3. Press the TITLE ON/OFF button on the remote control at the point on the tape where
you wish to record the title.
4. Press the TITLE ON/OFF button on the remote control again to stop recording the
title.
Note: Recording the title during tape transfer will erase a portion of your recorded material.
To Next Page
Loading...
