Advanced Techniques
43
5. Press the TITLE ON/OFF button on the remote control to store the corrected title in
memory.
Recording Title on a Tape in the Camera/Recorder
1. Hold down the red button on the CAMERA/OFF/VIDEO switch while sliding the
switch to CAMERA.
2. Locate the point of the tape where you wish to record the title ("Using Quick Edit," p
34).
3. Press the TITLE ON/OFF button on the remote control.
4. Use the PLAY button to select the title you wish to record.
5. Press the Start/Stop button to start recording the title.
6. Press the TITLE ON/OFF button on the remote control to stop recording the title. The
title graphics disappear from the viewfinder and the camera/recorder can record
normally.
Note: Create and store your title before an event you plan to record. Just press the TITLE
ON/OFF button on the remote control to superimpose the title over the scene as you record
it. This method avoids erasing previously recorded material which will happen when you
record a title on a previously recorded tape.
Note: Title recording is disabled when you connect the optional AV input cable to the AV
IN/OUT jack to record video and audio from the television or VCR.
Recording a Title while Transferring a Tape
1. Connect the camera/recorder to the VCR (p 26).
2. Press the TITLE ON/OFF button on the remote control to turn title on.
3. Use the PLAY button to select a title from memory.
4. Press the TITLE ON/OFF button on the remote control to turn title off.
5. Turn on the VCR and set it to record. Hold down the red button on the
CAMERA/OFF/VIDEO switch while sliding the switch to VIDEO. Press PLAY on the
camera/recorder.
6. Press the TITLE ON/OFF button on the remote control at the point on the tape where
you wish to record the title.
7. Press the TITLE ON/OFF button on the remote control again to stop recording the
title.
Note: Recording the title during tape transfer will erase a portion of your recorded material.
Using the Wireless Remote Control
Use the wireless remote control to operate the camera/recorder from a distance. The
PLAY, F.FWD, REW, STOP, PAUSE (START/STOP) and ZOOM buttons on the
wireless remote control operate the functions of the corresponding buttons on the
camera/recorder. Aim the wireless remote control at the infrared ray receiver of the
To Next Page
Loading...
