Hitachi VSP G200 - Initializing the Range of an Automatically Assigned Port Number

• You can specify multiple port-number-key-name and port-number-
range.
For example: MappPortRangeSet.bat PreRMIServer 51200-55000
SMIS_CIMOM 5989-6244,8000
3. Press any key to acknowledge the message and close the message box.
4. Close the Windows command prompt.
Initializing the range of an automatically assigned port number
You can initialize the range of the port number that is automatically assigned
to the storage system.
Procedure
1. Open the Windows command prompt as administrator on the SVP.
2. In the folder where the .bat file is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortRangeInit.bat
3. A confirmation message box displays.
• If you want to continue, enter Y, and then press the Enter key.
• If you want to cancel the task, enter N, and then press the Enter key.
4. Press any key to acknowledge the message and close the message box.
5. Close the Windows command prompt.
Configuring the storage system 135
System Administrator Guide for VSP Gx00 models and VSP Fx00 models