Hitachi YUTAKI Series - Page 131

ENGLISH

• Congure circuit 1 and circuit 2 OTC: Disabled, Points, Gradient, Fix.
• Enable or disable DHW and Swimming Pool.
• Select the heating source: HP only, HP + EH, HP + Boiler.
• Congure electrical heater use: Disabled or Backup.
• Congure Boiler type: Parallel or Serial.
• Congure Solar Combination options: Disabled, Input Demand, Total Control. (only in case DHW is enabled).
• Enable or disable Hydraulic separator status.
• Select Next and press OK button.

• Congure circuit 1 and circuit 2 options: Disabled, Points, Gradient, Fix.
• Only available for cooling mode.

• Enable or disable the desired modules (module 1 is enabled by default)
• Select Next and press OK button.

• Enable or disable the individual DHW for each module.
• Select Next and press OK button.
YUTAKI CASCADE CONTROLLER
PMML0510 rev.1 - 10/2019
121