Hitachi YUTAKI Series - Page 90


• Congure circuit 1 and circuit 2 options: Disabled, Points, Gradient, Fix.
• Only available for cooling mode.

• Enable or disable Cascade Mode.
• Congure Central mode options: Full, water, air or local. Only available when Cascade Mode is disabled.
• Congure thermostat 1 or 2 (depending on previous settings): None, wired or wireless.
• Check RT address if wired is selected.
• Select Wireless binding ID (1 or 2) if wireless is selected.
• Select Wizard complete and press OK button.

• Select Yes to complete the advance conguration.
• Press OK button to go to the main screen.
UNIT CONTROLLER
PMML0510 rev.1 - 10/2019
80