16
CHANNEL Button:
It is used to switch from Channel A to B or vice versa.
When changing a parameter value in the program, press the START/
ENTER button to make it blink, then change the value by pressing the DEC
and INC button. The value will be stored by repressing the START/ENTER
button. If there is a second parameter to edit on the same screen, it will
begin blinking after you con rm the rst parameter value.
When starting the progress, press and hold the START/ENTER button for 3
seconds. When stopping the progress or go back to previous step/screen,
press the BATT PROG/STOP button once.
When you rst power the charger on it displays the last processes used.
From here you can change the battery type or press enter to change the
charge/discharge process, charge/discharge current rate and/or battery
cell count. If you are charging a battery identical to the last one used and
want to perform the same process then simply press the start to begin that
process.
Input Functions Cont...
To Next Page
Loading...
Need help?
General
