5
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS
CONNECTED TO ITS POWER SOURCE. IF ANY MALFUNCTION
IS FOUND, TERMINATE THE PROCESS AT ONCE AND REFER
TO THE OPERATION MANUAL.
A The allowable AC input voltage is 100-240V AC.
A Keep the charger away from dust, damp, rain, heat, direct sunlight
and excessive vibration.
A If the charger is dropped or su ers any type of impact, it should be
inspected by an authorized service station before using it again.
A This charger and the battery should be put on a heat-resistant, non-
ammable and non-conductive surface.
A Never place a charger on a car seat, carpet or similar surface. Keep all
ammable volatile materials away from the operating area.
A Make sure you know the speci cations of the battery to be charged
or discharged to ensure it meets the requirements of this charger.
If the program is set up incorrectly, the battery and charger can be
damaged.
A Fire or explosion can occur due to overcharging.
A To avoid a short circuit between the charge lead, always connect the
charge cable to the charger rst, then connect the battery. Reverse
the sequence when disconnecting.
A Never attempt to charge or discharge the following types of
batteries:
Warning
Warning and Safety Notes [cont.]
To Next Page
Loading...
