User Manual Delivery and Storage
EM1 Series AC Servo Motors EM1-01-0-EN-2110-MA Page 39 of 72
7.2.1 Storage Ambient Conditions
Environmental parameter Unit Value
Air temperature
(°C)
-15 ~ 70
Relative humidity (%) 20 ~ 80
Rate of change of temperature
(°C/min)
0,5
Air pressure kPa 70 ~ 106
Condensation - Not allowed
Formation of ice - Not allowed
Delivery the motor in an environment with good protection. (indoor/factory)
7.3 Unpacking
Attention! Risk of Damage to Attachments!
Attachments may be damaged by mechanical loading.
No heavy load on the cover!
During unpacking, do not put any additional loads on the AC servo motors.
Note
The AC servo motor may only be unpacking indoors.
The AC servo motor provided with fly wiring with 50 W – 750 W. During unpacking, the AC
servo motor fly wiring must not be bended or pulled.
Steps to unpack the AC servo motor:
Unboxing the carton and take out the AC servo motor.
Remove protective film and shaft cover outside the AC servo motor.
Do not to touch the shaft by hand without glove prevent shaft from getting rusted.
Carefully handling the without bended or pulled the fly wiring from the AC servo motor.
Ensure the outlook and specific label on AC servo motor is the same with catalogue.
Dispose of packaging in an environmentally friendly way.
To Next Page
Loading...
Need help?
General
