HKS EVC - Page 32

−31−
３．StandardMode
３．１．BoostControl
WhiletheEVCisintheStandardMode,themaximumboostisdisplayedandautomatically
updatedinthedigitaldisplay(S),denotedwiththeP.Hillumination.Toresetvalue:
３．２．PeakHold
(１)IntheStanardsMode,pressthevolumeknobtoset
・TheEVCwillbeepandＰ．Ｈ．willilluminate;the
digitaldisplay(S)changesfrompeakholddisplay
totheblinkingtargetboostvalue.
・"ＳＥＴ"willalsoilluminate.
・TosetvalueforBMode,selectBModewiththe
volumeknob(turnright),thenpressknob.
(２)Turnthevolumeknobtosetthetargetboostvalue.
Whenthevalueisselected,pressthevolumeknobagain.
・TheEVCwillbeepandthedisplaysreturnstopeak
holddisplay.
・Theselectionrangeisfrombaselineboostto
250kPa/36.0PSI.
・Thetargetboostvaluesetintheinitialsettingis
thedefaultvalueforboothA&BModes.
(１)Pressthevolumeknobformorethan1second
・Thepeakholdvaluewillclearedandresetto
0kPaor0.0PSIaccordingly.
SettheboostvaluesforＡ/ＢmodesintheStandardMode.
ActivatetheScrambleboostfunctionbypressingButton①ortheexternalscrambleswitch.
３．３．Scramble
(１)AfterpressingButton①ortheexternalscramble
totriggeritsactivation,theEVCwill.
・Beeptoindicatethatthefunctionisactive.
・Thebargraphand"SBC"willblickandtheremaining
timeofthescramblewillbedisplayedonthedigital
display(S).
・Whenusingtheuserpresettimefunctionofthe
Scramble,thecountdowndoesnotbeginuntilthe
releaseofthebuttonorexternalswitch.
(３)ToturntheEVCoff,pressButton②formorethan１
second.RepeatsettoturntheEVCon.
・Anaudiblebeepwillbeemittedtoconfirmaction.
・WhentheEVCisoff,thecurrentboostreadingandthe
PeakHoldvaluewillbetheonlydatadisplayed.
www.R33-GTR.org