Example:
(Ref. 2-3; 1, Fig. 4)
tells the user to refer to Chapter/Section 2-3, and to see item 1, in Figure
4.
Once a Figure number reference has been established for a series of instructional steps, the Fig-
ure number is not repeated. Only the item numbers of parts involved are referenced.
For example, an instruction might appear like this: “Loosen screw
(2, Fig. 6),
slide out connec-
tor
(4),
and remove brush
(6)”.
When an item is referenced without a figure number, it will always apply to the last preceding
Figure number mentioned in the text.
NOTE 1: The word See may appear in some references, as (See Fig. 2). It means exactly the same thing
as Ref., however, its usage seems a little more direct and definite.
NOTE 2: When an “output cable” is mentioned in the manual, it refers to a large cable used to carry
output current. A special connector for the two output leads and the ground lead may be required when
delivering power directly to an aircraft.
7. SERVICE
If you have any questions concerning your Hobart Power Systems Division equipment, please contact
our Service Department by mail, telephone or FAX.
Write: Hobart Brothers Company
Power Systems Group
Service Department
Troy, Ohio 45373
U.S.A.
Call: Area Code (513) 339-5060
FAX: 513-339-4219
OM-2010
Introduction April 10/89 Revised
Page 4
To Next Page
Loading...
Need help?
General
