– 14 –
MAINTENANCE
Disconnect the electrical power to the machine and follow lockout / tagout
procedures.
LUBRICATION
Slideway
The slideways (Fig. 7) should be lubricated approximately twice a year. To reach these areas, fully lower
the bowl support. Wipe a thin coat of Lubriplate 630AA on the bowl pad area of the bowl supports and
on each slideway.
Planetary Seal
Occasionally, the planetary seal (Fig. 7) may become dry and begin to squeak. To correct this, work a little
lubrication (mineral oil) under the lip of the seal.
Planetary Seal
Slideway
Fig. 7
HL400 Technical Manual Page 22 of 80
To Next Page
Loading...
Need help?
General
