Hobby Siesta - Page 96

7. Electrical Installations
95
Manually calibrating the sensor
Openingthebattery circuitbreakerswitcheso theelectro-
nicsinthesuperstructure (seeitem:battery circuitbreaker).
Nowthesensorcancalibrateitself.Thisprocesstakesapprox.
threehours.Ifthebatterycircuitbreakeristhenswitchedon
again,avalueof“1”shouldbeshownonthedisplay.
Charger (charging the battery)
Battery is charged when the charger is con-
nectedtothe230Vmains.Theintegratedfan
is activated.
Batteryischargedviathegenerator.Motorhas
been started. Battery charger is not activated.
Duringcalibration,thevehiclemustnotbehookedupto
the230Vmains(thechargermustnotchargethebattery
duringcalibration).Furthermore,thevehiclemustnotbe
started while the sensor for the starter battery is being
calibrated.
Battery is charged when the charger is con-
nectedtothe230Vmains.Theintegratedfan
is deactivated.
Error messages
12:30 23,5 ° C
09.01. 15
18,0 ° C
Warning message: undervoltage
This warning appears when a voltage of 10.8V or less is
measuredforabatteryforadurationofatleast3minutes.
Theiconforthebattery,ancillaryorstarterbatteryinquestion
appearsinthemenu.
The message can be acknowledged; the battery should be
charged immediately.