17
07 How to Enable the AI Tracking
(AI vision sensor is sold separately)
1.Installing Magnetic Fill Light with
AI Vision Sensor (Sold separately)
Keep the "hohem" mark upward and
camera outward, then put the ll
light on the magnetic joint.
2. Enable the AI vision sensor:
Switch to "ON". (Indicator light
turns red with ll light ashing
twice.)
0.5~1.5m
3. Gesture Control: Show gestures
to the AI vision sensor from
0.5~1.5m(1.64ft-4.92ft) away.
4.Gesture "OK" to start the AI
tracking (Indicator light turns green).
5.Gesture "PALM" to stop the AI
tracking (Indicator light turns red).
It is completely normal for the magnetic alignment to become hot
when ll light is in long-time use and hence.
DO NOT make a direct contact with the hot alignment, especially
the metallic part.
To Next Page
Loading...
