TLi
IQ
System User Manual 2 – 5
Section 2 – Installation
GETTING STARTED
Turn the analyzer power switch to the ON position. The power switch is located on the left side of the instrument. (If the
analyzer does not turn on, see Section 6, Troubleshooting.)
The analyzer will perform SYSTEM DIAGNOSTICS (a self-test of the
analyzer components).
If there is a problem after the self-test, a beep will sound to indicate an
error and an error code will be displayed. If an error code is displayed,
refer to the troubleshooting section of the manual.
Once SYSTEM DIAGNOSTICS is complete, the display will change to the software VERSION, DATE, and TIME for five
seconds, and then to the fFN Main Menu. The date and time may need to be reset for your time zone.
To Next Page
Loading...