Holtkamp UNO Series - Operating the First Time; LED Operating Light

Holtkamp Electronics UNO 7600XL engl. techn. Stand 04.2016 4050_04.2016 V09.2019
- 11 -
Connection 230V Remote start (potential free)
8.5 Operatingthersttime
IftheUNOisinstalledcompletely,youcantakeintooperationby
switchingonthecircuit.Assoonasthecircuitisactivated,appe-
arsinthedisplayaninformationabouttheoperationmodeofyou
UNOandabouttheusedsoftware.(e.g.HoltkampXLSoftX.x
T-TimerFree).TheMAXIisnowreadyforoperationandcannow
beprogrammedasyoulike.Toensure,thattheprogramminghas
beencorrect,youshouldmakeadetailedtestrun.Afterthistest
run all counters should be deleted to receive a correct account.
Pleasemakesurethatyouradjustedmaintimeisappropriated
tothesunbed.Donotchoosethemaintimetoolong,becauseof
thedangerofthesunbedcustomer.Usetheadjustmentsetting,
to limit the maximum time and therefore limiting the maximum
accountofbuyablemaintimetoreducetoaminimumthedanger
tothecustomer.
8.5.1 LED operating light
WiththeLEDoperatinglightonecansee,ataglance,theope-
ratingstandoftheUNO.Duringthepre-runtime:quickblinking;
maintime:permanentlight;run-outtime:slowblinking.

March 2003 110% disconnection After norm EN 60335-
2-27/A11 (VDE 0700 part 27) Beginning with 01 may
2003 all our XL devices are equipped with the dis
connection recommended by the upper mentioned di-
rections.
EN60335-2-27The PCB of UNO is provided with a 110%-dis-
connection.Itmeans,thatanemergencystoptimeriscontrolled
by a third relay on the PCB. It guarantees the switching o󰀨 of
thesunbed,ifthemainrelayisnotswitchingo󰀨once,afterthe
expiredtime.