ASSEMBLY
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Seite 21
Drechselbank / wood turning lathe D 460FXL
On the device there are few of them serviceable components.
It is not necessary to dismantle the machine. Have repairs carried out only by a special-
ist-man!
Accessories: Only use HOLZMANN Accessories!
If you have any questions or problems, our customer support department.
12.4 Special safety regulations D 460FXL
12.5 Residual risks
Also in compliance with all safety regulations and if used properly following residual risks are
noted:
Risk of injury to hands / fingers by the rotating workpiece during operation.
Risk of injury from contact with live components.
Serious injury (especially cuts) by improper handling / management tools. Always away from
your body!
Hearing loss, unless arrangements have been made by the user for hearing protection.
Risk of injury from kickback the cut material, ejection of the cut material or portions of there.
Risk of injury to the eye by flying parts, even with goggles.
These risks can be minimized if all safety regulations are applied, the machine is properly main-
tained and cared for and the machine as intended and serviced by a trained service professional.
13 ASSEMBLY
13.1 Preparation
13.1.1 The Workplace
Select a suitable place for the machine.
Observe the safety requirements of Chapter. 12
You must also secure around a distance of at least 0.8 m around the machine.
13.1.2 Mounting the disassembled for transporting components
The machine is delivered pre-assembled. Prior to commissioning, but all (screw) are to check
connections for tightness.
It must be placed and fixed in the required position only the tailstock, as well as the hand rest
Etc. before turning Remove all tools such as moving iron from the machine bed!
Make sure that the palm rest is fixed before starting the work!
Use only properly sharpened tools
Avoid editing unwuchter and heavy workpieces!
To Next Page
Loading...
