To Next PageTo Next Page
Need help?Do you have a question about the Holzmann ED 400FD and is the answer not in the manual?
Understand the manual and labels for safe operation.
Maintain a clean, well-lit area free from hazards.
Machine use restricted to trained persons aged 18+.
Avoid loose clothing, long hair, and jewelry near moving parts.
Use safety glasses and ear protectors during operation.
Ensure correct current and professional installation.
Verify safety guards, buttons, and signs are functional and readable.
Shut down the machine and wait for parts to stop before leaving.
Use for turning/drilling metal/plastic; no other materials.
Avoid processing magnesium due to high burn risk.
Be aware of risks from rotating parts, chips, electrocution, and edges.
Avoid non-compliant use, exceeding limits, or use by untrained persons.
Inspect the shipping container contents against the list.
Position the lathe on a flat, level surface and secure it properly.
Quickly stops all machine functions; press green button to restart.
Swing, distance between centers, bed width.
Loosen set screws to remove, position new chuck, and tighten.
Adjust V-belt position on pulleys for desired speed range.
Clamp tools firmly with minimal overhang for accurate cutting.
Use table for feed/thread pitch; adjust gears if needed.
Lubricate all points and reservoirs to operating level before use.
General| Model | ED 400FD |
|---|---|
| Swing over bed | 400 mm |
| Distance between centers | 1000 mm |
| Center height | 200 mm |
| Voltage | 400V |
| Spindle speed | 50-2000 rpm |
