ENGLISH
This metal turning lathe shall be used expicitly for turning and
drilling of metal and plastic materials suitable for chip remo-
val.
The processing of other materials is not allowed!
never process magnesium - Burn Hazard!
Besides the information of this manual and the specic work sa-
fety rules valid in your country you should be familiar (through
proper education & experience) with the specic operation, sa-
fety and processing rules that have to be obeyed when working
with a metal lathe.
Do not wear gloves when working with the machine.
It might be catched in rotating parts and cause severe inju-
ries.
Comply to the rules of max. workpiece diameter, length etc ...
Always check the fastening tool to be mounted properly so that
it cannot become loose.
Check the workpiece for being fastened correctly.
Use the lathe chucks within the frame they are designed.
Do not attempt to fasten workpieces with diameters that do not
match with the chuck. Do not overfasten the chuck.
Process only short workpieces without tailstock.
Additionally, if the workpiece length is more than 3 times the
workpiece diameter, the workpiece has to be secured with the
tailstock as well by all means.
Avoid the combination of short fastening diameters with big
machining diamterers.
Avoid short fastening lengths
Always be informed about the technical limitations of your tools.
Especially - never use a tool at turning speeds that lie above the
max. alowed turning speed of the tool.
Perform tapping, threading in general and the machining of non
centrally fastenend workpieces only at slow turning speeds.
2. SPECIFIC RULES
CORRECT USE
OBEY THE SPECIFIC WORK RULES FOR METAL LATHES
To Next Page
Loading...
