Homematic IP HmIP-FROLL - Restore Factory Settings

39
Restore factory settings
1x orange
and 1 x green
lighting
Test display Once the test
display has stopped,
you can continue.
8 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the shutter actuator,
please proceed as follows:
• Press and hold down the system button (A) for at
least 4 seconds using a VDE screwdriver, until the
LED quickly starts flashing orange.
• Release the system button again.
• Press and hold down the system button again for
4seconds, until the LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
After the restart, you can again integrate your device into
your Homematic IP system.