36
Operation
6 Operation
After setup, you can perform initial operating functions
via the external shutter push-button:
• Short button press button S1 or S2: The motor
for the shutters/awnings moves into the corre-
sponding end position.
• Short button press opposite direction: The motor
stops.
• Long button press: The motor moves into the
corresponding direction until the push-button
is released or the end position of the shutter or
awning is reached.
7 Troubleshooting
7.1 Command not confirmed
If at least one receiver does not confirm a command, the
device LED lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see „9 General information about
radio operation“ on page 41). This may be caused be
the following:
• Receiver cannot be reached.
• Receiver is unable to execute the command (load
failure, mechanical blockade, etc.).
• Receiver is defective.
To Next Page
Loading...
