41
Installation
You can manually start the teach-in mode for another 3 min-
utes by pressing the system button briefly (D or L) .
• Your device will automatically appear in the app.
• To confirm, please enter the last four digits of the device number
(SGTIN) in your app or scan the QR code. Therefore, please see
the sticker supplied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up green. The device
is now ready for use. If the LED lights up red, please try again.
• Please select, in which application (e.g. climate control) you
would like to use the device.
• In the app, give the device a name and allocate it to a room.
5 Installation
5.1 Installation of the radiator thermostat
The radiator thermostat can be installed without draining heating
water or intervening in the heating system. No special tools are re-
quired, nor does the heating have to be switched o.
The union nut (A) attached to the radiator thermostat can be used
universally and without accessories for all valves with a thread size
of M30 x 1.5 from the most popular manufacturers such as Heimeier,
MNG, Junkers, Landis&Gyr (Duodyr), Honeywell-Braukmann, Oven-
trop, Schlösser, Comap, Valf Sanayii, R.B.M, Jaga, Siemens or Idmar.
By means of the adapter in the delivery, the device can be installed
also on radiator valves of type Danfoss RA (see „5.1.1 Mounting the
radiator thermostat“ on page 42).
To Next Page
Loading...
Need help?
General
