53
Start-up
• After power supply is established, the device will
be active for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (B)
shortly (see figure 13).
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED (B) lights
up green. The device is now ready for use.
• If the LED lights up red, please try again.
• After a short time, the newly connected device
appears in the inbox of your software interface.
Newly connected devices and the corresponding channels
are ready for operation and configuration only after they
have been configured in the inbox. You will find further in-
formation in the Homematic IP Wired Installation Guide,
available for download at www.homematic-ip.com.
For operation without Internet connection,
please select the option “Teaching-in of Home-
matic IP device without Internet connection”.
Please enter the SGTIN and key of the device into
the corresponding fields. You will find the SGTIN
and the key on the supplied sticker. Please keep
the sticker in safe place.
To Next Page
Loading...
Need help?
General
