Honda 08E91-E54-100 - Installing the Control Unit

© 2013 American Honda Motor Co., Inc. – All Rights Reserved. AII 50024-50373 (1308) 19 of 25
Installing the Control Unit
70. Using isopropyl alcohol on a shop towel, clean the
area where the urethane
tape will attach.
Q0N2305AG
URETHANE
TAPE
VEHICLE UNIT
(Clean with
isopropyl alcohol.)
71. Attach a piece of urethane tape to the vehicle unit as
shown.
72. Plug the antenna cable connector and the engine
st
arter connector into the control unit.
QC50917AB
ENGINE STARTER
HARNESS 28-PIN
CONNECTOR
CONTROL
UNIT
ANTENNA
CABLE
CONNECTOR
73. Attach the control unit bracket to the control unit.
QC50918AB
CONTROL
UNIT
CONTROL UNIT
BRACKET
74. Secure the clip from the engine starter harness fuse
block, and the clip from the engine starter harness
into the control unit bracket.
Q0N2308BG
CONTROL UNIT
BRACKET
ENGINE
STARTER
HARNESS
HOLE
CLIP
HOLE
CLIP
FUSE
BLOCK