Honda BF45A - Page 352

BF40AoBF50A
9) Disconnect the power trimhilt motor wire 2P connec-
tor.
10) Pull
off the trim angle sensor's three connectors from
the connector holder and disconnect them.
11) Unfasten the purse lock clip und pull out the trim
angle sensor wire through the hole of the
CDI unit
case.
12) Loosen the rivet screw and remove the 14 mm clip.
13) Remove the upper case grommet
C from the engine
under case and pull the power trimhilt motor and trim
angle sensor wires from the engine under case.
'CONNECTOR rn
I [l] CONNECTOR HOLDER
[2] CONNECTORS
I SENSOR WIREY \
SENSOR WIRE
TRIM ANGLE
SENSOR WIRE
GROMMET
13-6