32
STOPPING THE ENGINE
Emergency Engine Stopping
Normal Engine Stopping
OPERATION
EMERGENCY STOP SWITCH
GEARSHIFT LEVER
PUSH
EMERGENCY STOP SWITCH
EMERGENCY
STOP SWITCH
LANYARD
PULL
EMERGENCY STOP
SWITCH CLIP
THROTTLE GRIP
N (neutral)
Move the throttle grip to the
slowest speed and gearshift lever
to the N (neutral) position.
To stop the engine in an emergency,
pull the emergency stop switch clip
out of the emergency stop switch by
pulling the emergency stop switch
lanyard.
After cruising at full throttle, cool
down the engine by idling for a few
minutes before stopping the engine.
Press the emergency stop switch
until the engine stops.
We suggest that you stop the engine
this way occasionally to verify that
the engine and emergency stop
switch are operating properly.
When the boat is not in use,
remove and store the ignition
switch key and the emergency stop
switch clip and lanyard. If you are
using a portable fuel tank,
disconnect the fuel hose if you
will be storing or transporting the
outboard motor.
1.
2.
3.
11/03/07 16:32:04 31ZV1660_033
To Next Page
Loading...
