Honda CB360 - Engine Operation; Cold Engine Starting Procedure

START 1 М G T H E E N G | N E У/УЛУУУУУУУУУУУУУУУУ/УУГУУУУУУУУУУУУУЛУУУУУУУУУУУУУУУУУУГУ/ЛУ/УУУ УУУУ УУУУУУУУУУУ/ЛУ//УУУУ/ УУУУ /УУ//УУУ/У/ЛУ/У
Cold Engine Starting Procedure
1.
2.
Turn the fuel valve to the “ОМ”
position (page 20).
Insert the key into the main switch
and turn to the “ОМ” position. At this
time, observe the green neutral indica-
tor light (page 14). The light will be
lighted when the transmission is in the
neutral position.
. Make sure that the ignition switch
(page 16) is іп the “RUN” position.
. Raise the choke lever to the full closed
position 0).
. Open the throttle slightly and press
the starter button. If the engine does
not start within 5 seconds, release the
starter button and allow the starting
motor to rest for approximately 10
seconds before again pressing the
starter button. If the engine does not
start readily with the starting motor
use the kick starter pedal to start the
engine.
If the engine fails to start after several
repeated attempts, it may have be-
come flooded with excess fuel. To
clear the engine, turn off the main
25