Honda CB360 - Pre-Riding and Riding Procedures; Pre-Riding Inspection Checklist

Р В Е ы В | D 1 ма { N 5 Р ЕСТ IO N ХХХ” 7” 7 777777755555 TES
Prior to starting your motorcycle, per-
form a general inspection as a matter of
habit to make sure that the motorcycle is
in good, safe riding condition. This in-
spection will only require a few minutes
and can save you much time and expense
in the long run.
Check the following items and if adjust-
ment or servicing is necessary, refer to the
appropriate section in the manual.
1. Engine oil level-add engine oil if the
level is below the lower mark on the
dipstick (page 34).
2. Fuel level-fill fuel tank when necessary
(page 21).
3. Front and rear brakes—adjust free play
if incorrect (pages 56—64).
4. Tire pressure—adjust to correct pres-
sure (page 24).
5. Drive chain—check condition of drive
chain and measure chain tension. Ад-
just drive chain if chain tension is
incorrect. Lubricate the drive chain if
it appears dry. Replace the drive chain
if it is badly worn or damaged (pages
53—55).
. Throttle operation—check throttle
operation іп ай steering positions.
Adjust if free play is incorrect. Re-
place or correct cable routing if throt-
tle
does
not
operate
freely
in
all
steer-
ing positions (pages 47—48).
. Turn signal lights, tail/stoplight and
headlight—replace blown bulbs (pages
74—16).
23