Honda CB360 - Rear Wheel Removal and Installation

(СВЗ60)
1.
2.
Raise the front wheel off the ground
by placing a support under the engine.
Remove the cotter pin and dis-
connect the front brake cable from the
brake arm.
. Remove the speedometer cable set
screw and disconnect the speedometer
cable.
. Unlock the lock washer and remove
the front brake stopper arm bolt at the
backing plate.
. Remove the front axle holder nuts
(two on each side), and remove the
front axle holders (one on each side),
and then the front wheel can be
removed.
. To install the front wheel assembly,
reverse the removal procedure.
Rear Wheel Removal
1.
2.
Remove the muffler.
Unscrew the rear brake adjusting nut,
disassemble the brake rod from the
brake stopper arm and disconnect the
stopper arm from the backing plate.
. Remove the cotter pin from the end of
the axle.
. Unscrew the rear axle nut and pull out
the rear wheel axle.Tilt the motorcycle
to one side so that the wheel can be
removed.
. To install the rear wheel, reverse the
removal procedure.
73