Honda CB360 - Engine Starting Variations

switch and lower the choke lever to
the fully open position ®, open the
throttle and crank the engine using the
kick starter pedal. Turn the main
switch to the “ОМ” position and
follow the starting procedure outlined
in steps 1 through 5; however, at this
time use of the choke is not necessary.
6. After the engine starts, operate at
approximately 1,500 rpm until the
engine responds to the throttle when
the choke is open.
26
Starting in Extremely Cold Weather
Prime the engine before starting by crank-
ing several times with the Kick starter
pedal. The main switch or ignition switch
should be turned "OFF".
The choke should be fully closed and the
throttle opened. Then, follow the pro-
cedure for starting a cold engine.
Warm Engine Starting Procedure
When the engine is to be re-started while
it is still warm, follow the cold engine
starting procedure; however, the use of
the choke is not necessary.
WARNING:
+ Exhaust gases contain poisonous
carbon monoxide. Never run the
engine in a closed garage or confined
area.