Honda CB360 - Page 60

3. Loosen the clutch adjuster lock nut ©,
tum the clutch adjuster © in direction
® until a slight resistance is felt.
From this position, turn the adjuster
in direction 6) М turn.
Tighten the lock nut.
Clutch adjuster Tock nut E
Clutch adjuster
4. Turn the clutch cable lower adjuster @
(page 51) in direction ® so there is
52
0.4—0.8 in. (10—20 mm) of free play
at the clutch lever, then tighten the
lock nut 0).
Perform any subsequent minor adjust-
ments with the clutch cable upper
adjuster.
. After the adjustment has been made,
ensure that the clutch is not slipping
and that the clutch is properly dis-
engaging.
After the engine starts, pull in the
clutch lever and shift into gear, and
ensure that the engine does not stall,
nor the motorcycle start to creep.
Gradually release the clutch lever and
open the throttle. The motorcycle
should start smoothly and accelerate
gradually.