Honda CB360 - Page 63

Lubrication:
Normally drive chain lubrication is per-
formed without removing the chain, at
the time of chain adjustment.
More frequent inspection and servicing is
required under severe operating con-
ditions.
a. The CB360 and CB360G are equipped
with the endless type drive chain and
requires periodic inspection. If dirty or
rusted, clean with brush and solvent,
wipe and dry with a clean rag. Inspect
the chain for wear (sloppy joints),
stiffness and binding at the joints, and
broken or separated rollers. Apply a
liberal amount of good engine oil or
chain lubricant.
If damaged or worn, the chain should
be replaced. Replacement of the end-
less chain requires a special tool, there-
fore your Honda dealer should be
consulted.
. Adjust drive chain as described in steps
“а—е”, page 54.
55