Honda CB360 - Page 74

к.
·
The
deflated
inner
tube
can
now
be
pulled
from
the
tire
casing
and
the
inner
tire
casing
inspected
for
damage
or
protruding
sharp
object,
etc.
Locate
and
eliminate
cause
of
flat
or
punc-
ture.
.
If
the
tire
is
to
be
replaced,
pry
the
other
tire
bead
from
the
wheel
rim
as
described
in
step
e,
and
remove
the
tire
from
the
rim
(this
step
is
not
necessary
if
only
the
inner
tube
is
to
be
replaced).
Install
one
bead
of
the
new
tire
in
the
wheel
rim
and
proceed
with
installation
of
the
inner
tube.
.
Install
a
new
inner
tube
of
the
correct
size
by
inflating
very
slightly.
Leave
the
valve
core
in
the
valve
stem.
.
Inspect
the
wheel
rim
inner
tube
pro-
tector
strip
to
see
that
it
is
in
good
condition
and
centered
over
the
spoke
nipples.
.
Align
the
tire
balance
mark
with
the
66
valve stem hole in the rim and insert
the partially inflated inner tube into
the tire casing.
. Work the inner tube into proper posi-
tion in the tire casing and insert the
valve stem through the valve stem hole
in the rim. Install a valve stem retain-
ing nut partially, but not tightly onto
the valve stem. Remove valve core.
. Apply a light coating of tire mounting
solution (liquid detergent can be used
in an emergency) to each of the tire
bead surfaces, and between the free
tire bead and rim edge.
. The tire can now be stepped into place
using your heels. Place both heels on
the tire bead opposite the valve core
and press the tire bead into place
progressively with each step in op-
posite directions around the wheel.