−
−
1.2 US qt (1.1
)
15 lbf·ft (20 N·m , 2.0 kgf·m)
102
Engine Oil & Strainer Screen
Servicing Your Honda
Improper disposal of drained f luids is
harmf ul to the environment.
Pour the drained oil into a suitable
container and dispose of it in an
approved manner (page ).
Install the oil filler cap/dipstick securely.
Lock the rear wheel (page ).
Start the engine and let it idle for 3 5
minutes.
Make sure there are no oil leaks.
If a torque wrench is not used for
installation, see your Honda dealer as
soon as possible to verify proper
assembly.
Fill the crankcase with the
recommended oil (page ),
approximately:
Install the oil strainer screen, spring and
oil plug. Tighten the oil plug to
specified torque:
Check the oil strainer screen, sealing
rubber, and oil plug O-ring are in good
condition.
Clean the oil strainer screen.
Stop the engine. Wait 2 3 minutes.
Check that the oil level is at the upper
level mark on the oil filler cap/dipstick.
5.
22
6.
7.
8.
9.
12.
13.
14.
10.
11.
157
94
04/10/19 10:51:02 31KSZ610_111
To Next Page
Loading...
