EasyManua.ls Logo

Honda REFLEX - Starting & Stopping the Engine; Preparation

Honda REFLEX
233 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
Preparation
Starting & Stopping the Engine
Basic Operation & Riding
Always follow the proper starting
procedure described below.
For your safety, avoid starting or operating
the engine in an enclosed area such as a
garage. Your scooter’s exhaust contains
poisonous carbon monoxide gas which can
collectrapidlyinanenclosedareaand
cause illness or death.
Your scooter is equipped with a side stand
ignition cut-off system. If the side stand is
down––the engine cannot be started.
Operate the starter button for slightly
longer than usual without opening the
throttle if the scooter has been left
standing for a long time or when the fuel
tank has just been refilled.
Before starting, insert the key, turn the
ignition switch ON, and confirm the
following:
The engine stop switch is set to RUN.
This scooter has an automatic fuel valve
and starting enrichment thermal valve;
there is no manual operation.
Do not use the electric starter for more
than 5 seconds at a time. Release the start
button for approximately 10 seconds
before pressing it again.
04/10/19 10:43:28 31KSZ610_054

Table of Contents

Related product manuals