41
SERVICING YOUR PUMP
Installation:
1. Install the O-ring on the pump cover, taking care not to damage the O-ring.
2. Install the pump cover on the pump casing, and tighten the knobs hand
tight. Then, set the wrench to the knobs and finish tightening the knobs
evenly.
3. Install the drain plug in the pump cover.
4. After tightening the pump cover knobs, check the pump cover and pump
casing to ensure that there is no water leakage.
WRENCH
KNOBS (4)
VOLUTE CASE
O-RING
DRAIN PLUG
PUMP COVER
PUMP CASING
31YG06130.book 41 ページ ２０２１年１月２０日 水曜日 午前９時２７分
To Next Page
Loading...
