Honeywell 7820 Solaris User Manual

41
TROUBLESHOOTING GUIDE
SYMPTOMS POSSIBLE CAUSE(S) SOLUTION
Scanner beeps
at some bar
codes and NOT
for others of the
same bar code
symbology.
The bar code may
have been printed
incorrectly.
Check if it is a check
digit/character/or border
problem.
The scanner is not
configured correctly for
this type of bar code.
Check if check digits are set
properly.
The minimum symbol
length setting does not
work with the bar code.
Check if the correct minimum
symbol length is set.
Multi-Function
Button is not
working.
A faulty push button
switch.
Contact a customer service
representative.
Keyboard Wedge Only
The unit scans
the bar code but
there is no data.
Configuration is not
correct.
Make sure the scanner is
configured for the appropriate
mode.
The unit scans
but the data is
not correct.
Configuration is not
correct.
Make sure that the proper PC
type AT or PS2 is selected.
Verify correct country code and
data formatting are selected.
Adjust the intercharacter delay.
The unit is not
transmitting
each character.
Configuration is not
correct.
Increase the interscan code
delay setting. Adjust whether the
F0 break is transmitted. It may
be necessary to try this in both
settings.
Alpha characters
show as lower
case.
Computer is in Caps
Lock mode.
Enable Caps Lock detect setting
of the scanner to detect whether
the PC is operating in Caps Lock.

Honeywell 7820 Solaris Specifications

General

Brand	Honeywell
Model	7820 Solaris
Category	Barcode Reader
Language	English