Honeywell BW Technologies GasAlert MicroClip XT - Calibration Due Date and Failure Warnings


GasAlertMicroClip
Activating the Detector
Last Calibration Failed (optional)
,IDQ\VHQVRUIDLOHGWKHODVWFDOLEUDWLRQ&$/)$,/85(GLVSOD\V
RQWKHVFUHHQ
Note
When the CAL FAILURE displays, the previous calibration has
failed but the calibration is still valid until the next calibration due
date.
Overdue Calibration
,IDQ\VHQVRULVSDVWGXHIRUFDOLEUDWLRQWKHGHWHFWRUEHHSV
IODVKHVYLEUDWHVDQGWKHIROORZLQJVFUHHQGLVSOD\V
,IFDOLEUDWLRQLVRYHUGXHDQGWKH)RUFH&DOLEUDWLRQ:KHQ
2YHUGXHRSWLRQLVHQDEOHGDFDOLEUDWLRQPXVWEHSHUIRUPHGWR
HQWHUQRUPDORSHUDWLRQ5HIHUWR&DOLEUDWLRQ

Note
If calibration is not performed, or
C is not pressed within
2 minutes, the detector automatically deactivates.
,IWKH)RUFH&DOLEUDWLRQ:KHQ2YHUGXHLVGLVDEOHGSUHVV
CWR
DFNQRZOHGJHWKHZDUQLQJ7KHGHWHFWRUFRQWLQXHVZLWKWKH
VWDUWXSVHOIWHVWVDQGWKHQHQWHUVQRUPDORSHUDWLRQ
Cal IR Lock
,IWKH&DO/RFNRSWLRQLVHQDEOHGWKHIROORZLQJVFUHHQGLVSOD\V
5HIHUWR6WDUWXS7URXEOHVKRRWLQJ

Bump Test
Note
A bump test cannot be conducted if the detector has just been
calibrated. If the Bump Interval
option is defined as  in Fleet
Manager II, the bump test is bypassed.
BW recommends to “bump test” the sensors, before each day’s
use, to confirm their ability to respond to gas by exposing the
detector to a gas concentration that exceeds the alarm setpoints.
www.CanarySense.ca
Shop for Gas products online at:
1.800.561.8187